iFixit - Answers With Device "Computer Game Controller"

Thrustmaster T3PA Pedals: My t3pa pedals clutch not working

Wed, 08 Apr 2026 10:32:36 -0700

My t3pa pedals are not working. I have tried all the resetting stuff its not that the clutch acts as an accelerator, and so does the gas pedal with my t150

⟐ Commented 4월 08, 2026 at 10:32 GMT-7

Thrustmaster T3PA Pedals: My t3pa pedals clutch not working

Tue, 07 Apr 2026 10:22:31 -0700

My clutch is acting as a gas pedal, but my gas pedal acts as a gas pedal to they bth move the car

⟐ Marked as duplicate 4월 07, 2026 at 10:22 GMT-7

GameSir G7 SE: Replacing the rumble motor on a Gamesir G7 SE

Tue, 07 Apr 2026 00:27:05 -0700

I have an out-of-warranty Gamesir G7 SE. The left grip motor only works when the controller is either shaken or tapped/hit against a hard surface. The motor works for a while and then dies out again. Contact cleaner didn't help.

Can I use a motor from another (XBox or PlayStation) controller to replace it? I know I would have to reuse the old (Gamesir) connector and re-solder the wires. Which colored wires should be soldered together? I'm presuming Gamesir black to (XBox/PlayStation) black and Gamesir gray to (XBox/PlayStation) red.

The motor inside the right-handed trigger is out completely, but my priority is focused on the motor inside the left-handed grip.

Gamesir chooses not to sell replacement parts (reddit: r/Gamesir from 2025)

⟐ Answered 4월 07, 2026 at 0:27 GMT-7

Thrustmaster T3PA Pedals: clutch not working it

Fri, 03 Apr 2026 15:59:52 -0700

The clutch acts as an accelerator, and so does the gas

Computer Game Controller: Redgear pro series wireless gamepad receiver

Mon, 30 Mar 2026 08:25:10 -0700

My redgear pro series wireless gamepad receiver has been broken what can I do to fix it? Or can you suggest a universal receiver as a replacement I don't want to buy a new gamepad when I have a good one.

⟐ Commented 3월 30, 2026 at 8:25 GMT-7

RIPPA RA903B Controller: The r2 button is not working

Mon, 30 Mar 2026 04:00:18 -0700

Why is the r2 button not working

⟐ Answered 3월 30, 2026 at 4:00 GMT-7

Scuf Instinct Pro: continued stick drift after replacing

Sun, 29 Mar 2026 22:11:32 -0700

i have replace the left stick of a buddies controller with 2 separate modules. however it still has same problem where it reads straight up at 100%, dosnt register down input. but left and right work fine. is there something else to check that can cause this problem?

8BitDo SN30 Pro Gamepad: How can I replace the battery?

Thu, 26 Mar 2026 09:58:24 -0700

Ware can I buy and how can I replace the battery in it?

참고:

It is stuck with adhesive

⟐ Answered 3월 26, 2026 at 9:58 GMT-7

PowerA ProEX Xbox 360 Wired Controller: Why is the light on the Xbox button not working?

Mon, 09 Mar 2026 18:55:43 -0700

The four lights surrounding the Xbox button are not lighting up. Any advice would be appreciated.

⟐ Answered 3월 09, 2026 at 18:55 GMT-7

Afterglow Prismatic Wired Controller for Xbox One: Why won't it turn on?

Fri, 06 Mar 2026 19:17:18 -0700

I plug the controller in to my PC or Xbox and it won't turn on, Any help is appreciated

⟐ Commented 3월 06, 2026 at 19:17 GMT-7

Les Paul Wireless Guitar: Green + red + yellow cause strum

Mon, 02 Mar 2026 10:24:14 -0700

Hi, having an issue where pressing the first three frets at once causes a downstrum. When I hold these frets, I can still strum up after the first downstrum has happened, but strumming down has no effect.

I have already resoldered the neck connector pins and have even gone as far as to completely unsolder the entire 14-pin strum bar connector from the "main" board, the one with the Xbox button. As far as I can tell, none of the connections on that 14-pin board are shorted to the one next to it and I've run out of ideas.

What could I do next to try and pinpoint the problem? Has anyone fixed an issue like this on their controller?

⟐ Answer accepted 3월 02, 2026 at 10:24 GMT-7

Viture 8BitDo Ultimate C Bluetooth Gaming Controller - Black: L2 And R2 Triggers Dont Work On Certain Games

Sun, 01 Mar 2026 20:53:29 -0700

Bought From Micro Center looking around for answers about this came up mostly short, a solution was to try their software i dont have my pc build completed yet minus some ram getting delivered (used, ebay).

I had a workaround for another third party controller(dont remember the name got it from newegg) for retro arch it let me map out the gas and pedal(dont remember if they were analogue or not) designated l2 and r2 i forgot to bookmark where i found it though.

I tried the triggers on https://hardwaretester.com/gamepad and they work there they are b6&b7 repectively

⟐ Commented 3월 01, 2026 at 20:53 GMT-7

PDP Victrix Pro BFG: PS5/PS4/PC Switch Broken, possible quick fix/bridge?

Sun, 01 Mar 2026 14:27:20 -0700

Heard a slightly chunkier 'snap' than normal when trying to switch from PS5 mode to PC mode, inspection revealed attached image. The parts that I suspect belong to the working parts of the switch assembly are in indiscernible pieces now (except for the small metal brace that went over the top of them like a shell). The controller is currently stuck in PS5 mode and I would like to be able to switch back to PC. I am completely unsure as to how the original switch worked and don't want to start trying to bridge the contacts at random until I have a better idea of how the original switch was lain out/functioned. Not sure how easy it would be to get a picture of a working assembly and the contacts, but I would greatly appreciate any help!

Logitech Driving Force GT E-X5C19: My steering wheel doesn't work.

Fri, 27 Feb 2026 23:29:32 -0700

My steering wheel doesn't work.

BSP-D9: Why is my bsp d9 controller blinking purple and white light?

Sat, 21 Feb 2026 03:58:16 -0700

Why is my bsp d9 device blinking white and purple light ?

Logitech G29 Driving Force: Why does one button on my wheel activate all the others and disconnect

Sat, 14 Feb 2026 21:56:53 -0700

When pressing either the X or square button on my g29 as they are the only buttons that work (although the steering pedals and gear shifter work as usual) on the steering wheel. Once pressed it shows as if multiple buttons are pressed although you are only pressing the one and the wheel disconnects and recalibrates. Any help is appreciated!

Computer Game Controller: The pad it's not function at all and it's not work at all

Fri, 13 Feb 2026 02:37:13 -0700

What can I do now

⟐ Commented 2월 13, 2026 at 2:37 GMT-7

Power A Fusion Pro wireless controller for ps4: How to replace battery

Tue, 10 Feb 2026 14:25:47 -0700

It won’t hold a charge

PDP Victrix Pro BFG: My controller is disconnected but there is vibrating humming noise

Wed, 04 Feb 2026 08:30:47 -0700

my controller is disconnected but it seems to be vibrating and making a Humming noise, plus it wont connect

Logitech G29 Driving Force: Why is my steering wheel constantly disconnecting

Sun, 01 Feb 2026 05:13:06 -0700

I have a g29 that I have had since Christmas of 2022 in November of 2025 it started disconnecting randomly and I wanted to know how to fix it so I watched a video that told me to tape over the end of the ground wire of all three pedals and It didn’t work I don’t want to have to take apart the wheel or the pedals again but I really don’t want to be forced to buy a new one

⟐ Commented 2월 01, 2026 at 5:13 GMT-7