도움말

원문 게시자: oldturkey03 ,

본문:

Jim, check you brake light switch. Check [http://forums.vwvortex.com/showthread.php?1158315|on here] for more information. To replace the switch :" On the new brake switches you START with the plunger all the way out. Holding the brake pedal UP install the brake switch and turn until it latches. This will set the Plunger in the correct spot.

Pull out brake light switch plunger to full extension.

Keep brake pedal in up position (IMPORTANT! hold pedal up if necessary while installing switch).

Guide switch through mounting hole (only fits in one position).

Seat switch fully into opening (pressing plunger against pedal to adjust.

Seat switch by turning it 45 clockwise. This action also turns the plunger shoe into the correct orientation to make electrical contracts in switch operate as well as locks in plunger adjustment.

Connect brake light switch connector.

Operate brake pedal to verify proper function.

Reinstall lower cover panel." Hope this helps, good luck.

현황:

open