"Replacement heatsink hold-down pins?"의 기록

2017년 11월 15일

현재 버전 작성자: phunguss

텍스트:

	Since the resurrected motherboard I have is going into a cube case and was missing the original heat sink, this alternate was held in place with zip ties.

	I just used small zip ties about 3-4 inches long. Ran one down from the top then back up from the bottom... and used a second one to bridge across. Add two more for the other set of holes. Not spring loaded, but holds it on there with no problem.

	[image\|502591\|align=left]
+
+	=== Update (11/15/2017) ===
+
+	Zip ties with original springs: [image\|1260266]
+	[image\|1260265]

현황:

open

2015년 3월 9일

원본 게시물 작성자: phunguss

텍스트:

Since the resurrected motherboard I have is going into a cube case and was missing the original heat sink, this alternate was held in place with zip ties.

I just used small zip ties about 3-4 inches long.  Ran one down from the top then back up from the bottom... and used a second one to bridge across.  Add two more for the other set of holes.  Not spring loaded, but holds it on there with no problem.

[image|502591|align=left]

현황:

open