Skip to main content
도움말

현재 버전 게시자: Robert Ciaccio ,

본문:

It seems to be dependent on the screwdrivers... I bought a set of bits at fry's and the #00 was too smallsmall and I had to use the #0. They turned out to be pretty crappy quality, so I ordered the 54 bit set from ifixit, and the #00 fits perfectly. Just make sure that before you start using any pressure, the screwdriver is seated quite firmly into the screw without a lot of "wiggle". If its too small or large, you'll end up with a stripped screw.
It seems to be dependent on the screwdrivers... I bought a set of bits at fry's and the #00 was too smallsmall and I had to use the #0. They turned out to be pretty crappy quality, so I ordered the 54 bit set from ifixit, and the #00 fits perfectly. Just make sure that before you start using any pressure, the screwdriver is seated quite firmly into the screw without a lot of "wiggle". If its too small or large, you'll end up with a stripped screw.
 
In general though, if you have the time, I'd order the bit set from here since overall they were much higher quality than anything I had a available locally. Only took about 3 days for me to get them as well :)

현황:

open

원문 게시자: Robert Ciaccio ,

본문:

It seems to be dependent on the screwdrivers... I bought a set of bits at fry's and the #00 was too small.  They turned out to be pretty crappy quality, so I ordered the 54 bit set from ifixit, and the #00 fits perfectly.  Just make sure that before you start using any pressure, the screwdriver is seated quite firmly into the screw without a lot of "wiggle".  If its too small or large, you'll end up with a stripped screw.

In general though, if you have the time, I'd order the bit set from here since overall they were much higher quality than anything I had a available locally.  Only took about 3 days for me to get them as well :)

현황:

open