주요 콘텐츠로 건너뛰기
도움말

원문 게시자: Jimfixer ,

본문:

Without testing it you wont know what to replace

Once it dried out the corrosion on the inside began and is now causing problems . If you had taken the laptop apart immediately after the water was introduced you could have cleaned the logic board and then you could have saved the laptop but it is probably corroded beyond help now . This is my pet answer for wet laptop you can try this it may help . If you have access to a sonic bath put the logic board it there to clean it ,if not then try the following

Clean every connection with a soft toothbrush. As well clean the logic board use a 99% isopropyl alcohol for all cleaning. Now is the time to start drying out the laptop. Set the screen in a desiccant or silica gel leave it in for several days moving it from time to time to get the max effect from the desiccant. Use a blow dryer on a low heat setting to dry the rest of the laptop. Only use a hair dryer once you have cleaned the laptop completely with the alcohol. Do not attempt to dry the laptop if it’s still wet with water with the blow dryer as this only spreads the water. Replace the battery with a new one considers the old ones done. Clean again with isopropyl alcohol let dry and when you think everything is clean and dry reassemble the phone (make sure to clean the contacts on the screen after removing from the desiccant). Once you've reassembled the laptop it’s time to power it on. Hold your breath and hope for the best

For great diagnostic help check out Louis Rossmann on youtube

현황:

open