주요 콘텐츠로 건너뛰기
도움말

원문 게시자: Stephen Elliott ,

본문:

I would try these steps in order.

1- Open the phone, take out the board and check ( J1111 ) if it's damaged

or shorted repair it. Try to restore the phone without connecting the

front camera flex.

2- Check ( U0301 ) IC if it's cracked or damaged, resolder or replace.

3- Take out the board and remove the metal sheild over the NAND chip

(the U0604 chip in the picture). check if ther is any damaged component

around the chip, or if there any water damage (clean it ).

Check if there is any shorted (capacitor, resistor, coil) around the chip

then replace it.

4- resolder the NAND chip using heater (use the same tempereture you

use usually to remove ICs). heat for about 15 seconds and don't forget

to protect the ICs around the chip.

5- Replace the NAND chip but be carfull ( don't heat to much cause you

got the CPU in the other side). Don't go to this step befor being sure

that you did all the previous steps and there is no problem connecting

to Apple server.

현황:

open