주요 콘텐츠로 건너뛰기
도움말

원문 게시자: jayeff ,

본문:

Hi,

As you know water and electronics and electricity are not a good mix.

The minerals in the water cause corrosion and the water also provides circuit paths for the electricity which were not in the DSi's operating design and could damage the components. The corrosion process starts immediately and will not stop until it has been thoroughly cleaned away.

First  '''remove the battery as soon as possible''' from the DSi  to minimize further damage.''

Then you need to completely dis-assemble the rest of the DSi and clean all the affected parts using Isopropyl Alcohol 90%+ to remove all traces of corrosion and water. Do not use "rubbing alcohol" as in some cases this is only 70% or less and is not as effective. If you do check the label to verify the amount

Here is a link that in general  describes the process.

[[Electronics Water Damage]]

As always with electronics, especially surface mounted PCBs be gentle when handling and especially when brushing away the corrosion. You do not want to remove any components from the board.

Here is a link to the Ifixit guides on how to repair the DSi, which may be of some help.

[[Topic:Nintendo DSi]]

현황:

open