주요 콘텐츠로 건너뛰기
도움말

현재 버전 게시자: Juax ,

텍스트:

Morning friend,
When you did the replacement did you verify that you put the proper screws in place? I strongly encourage to open the unit again and reinspect your work.
-Follow the guide [http://What did you do prior to the "no service". * Does your carrier have any issue with your sim? * Did the unit get wet? * Was it dropped? * Update any of the software/firmware? * Is there an software update for your unit? This can update carrier settings which could resolve the issue. * Have you attempted to restart the phone to see if service will reconnect? * Did you add any other APNs, which could interfere with service depending on the provider. * Ensure you're not in Airplane Mode. |here] take note of the screws, disconnect the battery, reseat the cables to ensure they are seated properly, and try again.
+Follow the guide [https://www.ifixit.com/Guide/iPhone+7+Plus+Display+Assembly+Replacement/67563|here] take note of the screws, disconnect the battery, reseat the cables to ensure they are seated properly, and try again.
If that does not work, there could be an issue with the part. Just ensure that no plastic was left on that part while you open the device.
Hope this helps.

현황:

open

원문 게시자: Juax ,

텍스트:

Morning friend,

When you did the replacement did you verify that you put the proper screws in place? I strongly encourage to open the unit again and reinspect your work.

Follow the guide [http://What did you do prior to the "no service". * Does your carrier have any issue with your sim? * Did the unit get wet? * Was it dropped? * Update any of the software/firmware? * Is there an software update for your unit? This can update carrier settings which could resolve the issue.  * Have you attempted to restart the phone to see if service will reconnect?  * Did you add any other APNs, which could interfere with service depending on the provider. * Ensure you're not in Airplane Mode. |here] take note of the screws, disconnect the battery, reseat the cables to ensure they are seated properly, and try again.

If that does not work, there could be an issue with the part. Just ensure that no plastic was left on that part while you open the device.

Hope this helps.

현황:

open