주요 콘텐츠로 건너뛰기

기기를 수리하세요

수리할 권리

상점

도움말

원문 게시자: Michael ,

텍스트:

From what I have read (Not from experience) it is most likely caused by either a corrupt NAND or from overheating NAND during Tristar and caused bridge or cold solder joint. If you have the NAVIPRO 3000, you could remove it, reprogram and install, if not, you could reball and try again.

But this is from "Reading" about the issue and could be wrong...just an idea and would seek out expert advice from @refectio or @jessabethany before going to such extremes.

I did read on one post that to remove FMI if on but not sure if that would cause a SN issue.

Please repost answer you find I'd be interested in knowing what repair worked for you

현황:

open