주요 콘텐츠로 건너뛰기
도움말

현재 버전 게시자: Juan Lara ,

본문:

Does the device show the Charge Indicator in the battery?
 
If '''Yes''' the problem is that you could have been given a defective battery, I would first check the connection to make sure It's properly making contact. If so the problem maybe the terminal for the battery itself may have been damaged, the post is fragile and It could be damaged when pulling the latch to release the battery connector. If that checks out then you have a defective battery
 
If '''It does not''' the issue is with the 30 pin connector itself. That connector often has a lot of lint that may need to be cleaned out. Using a very thin tool like and iSesamo and a pick can help, be careful since you don't want to damage the pins. If It's clean then the port itself is bad and needs to be replaced, that involves micro soldering.
 
My best advice is to buy a known good similar device if it happens to be anything involving the board, and just swap the drive if the files in the device is what isare an important factor just use a zip drive reader to youpull files out of the device.
My best advice is to buy a known good similar device if it happens to be anything involving the board, and just swap the drive if the files in the device is what isare an important factor just use a zip drive reader to youpull files out of the device.

현황:

open

원문 게시자: Juan Lara ,

본문:

Does the device show the Charge Indicator in the battery?

If '''Yes''' the problem is that you could have been given a defective battery, I would first check the connection to make sure It's properly making contact. If so the problem maybe the terminal for the battery itself may have been damaged, the post is fragile and It could be damaged when pulling the latch to release the battery connector. If that checks out then you have a defective battery

If '''It does not''' the issue is with the 30 pin connector itself. That connector often has a lot of lint that may need to be cleaned out. Using a very thin tool like and iSesamo and a pick can help, be careful since you don't want to damage the pins. If It's clean then the port itself is bad and needs to be replaced, that involves micro soldering.

My best advice is to buy a known good similar device if it happens to be anything involving the board, and just swap the drive if the files in the device is what is important to you.

현황:

open