Skip to main content
도움말

원문 게시자: Abrsvc ,

본문:

I would first verify that the ribbon cable for that side of the panel is installed correctly.   Assuming that the replacement T-con board is not faulty, the connections would be the first  thing to check.  Re-seat both ribbon cables and post the results.  Also check the cables themselves looking for any damage to the cable.

You can also look at the connector on the board to see if there is any damage.  It is also possible that the solder connections for the connector itself may be cracked or damaged.  If you can post a picture of the connectors, that may be helpful as well.

If the set was working as expected prior to the T-con failure, I would not suspect the panel at this time, but it is possible that the panel was on the verge of failure prior to the T-con failure.  While possible, I would expect this to be extremely remote.

Dan

현황:

open