주요 콘텐츠로 건너뛰기
도움말

현재 버전 게시자: Jefe Christe ,

텍스트:

I have the same iMac 27" i7 mid-2011 and it is new to me, refurbished, with an extended 2 yr. warranty.
 
When purchased, according to the specs only had a 1 tb HDD.
 
The NICE surprise is it also shows a 256gb Apple SSD TS256C installed (along with 8gb < 16 gb RAM and 1gb <2gb RAM on the video card - all surprise upgrades from Mac of all Trades!
 
ISSUE IS:
 
On both hard drives it shows
 
Link Speed = 6 Gigabit
 
Negotiated Link Speed = 3 gigabit
 
NOW... could this be reconfigured through a software solution, to run as fast as it should??
 
=== Update (01.08.2018) ===
 
Again-
On both hard drives it shows:
Link Speed = 6 Gigabit
HOWEVER it shows a
Negotiated Link Speed = 3 gigabit
 
...So clearly if two out of the three cables are supplying 6 GP/S
And the link speed reads an initial 6 GP/S on both HDD and SSD....
 
It would appear that they each have the proper port for that part of the configuration ( if one of them was in the optical Port, a starting link speed of 3GP/S, not 6, would show as the link speed)
- then there must be a different answer (possibly SOFTWARE configuration answer)?

현황:

open

원문 게시자: Jefe Christe ,

텍스트:

I have the same iMac 27" i7 mid-2011 and it is new to me, refurbished, with an extended 2 yr.  warranty.

When purchased, according to the specs only had a 1 tb HDD.

The NICE surprise is it also shows a 256gb Apple SSD TS256C installed (along with 8gb < 16 gb RAM and 1gb <2gb RAM on the video card - all surprise upgrades from Mac of all Trades!

ISSUE IS:

On both hard drives it shows

Link Speed = 6 Gigabit

Negotiated Link Speed = 3 gigabit

NOW... could this be reconfigured through a software solution, to run as fast  as it should??

현황:

open