주요 콘텐츠로 건너뛰기
도움말

현재 버전 게시자: jayeff ,

텍스트:

Hi @ernieu717
 
As you know water and electronics and electricity are not a good mix.
 
''The impurities it the water causes corrosion and provides circuit paths for the electricity which were not in the camera's operating design and could damage the components.''
 
''First '''do not turn on your camera''' and then you need to '''remove the battery as soon as possible''' from the camera'' to minimize further damage.
 
Then you need to dis-assemble the rest of the camera and clean ''all the affected parts'' using '''Isopropyl Alcohol 90%+''' (available from electronics parts stores) to remove all traces of corrosion and water. Do not use "rubbing alcohol" as in some cases this is only 70% IPA or less, can contain scents and is not as effective. If you do have to use it check the label to verify the amount of IPA
 
Here is a link that describes the process.
 
[[Electronics Water Damage]]
 
As always with electronics, especially surface mounted PCBs be gentle when handling and especially when brushing away the corrosion. You do not want to remove any components from the board.
 
Hopefully after you have done all this the camera ''might'' possibly work correctly again.
 
Here is a link to the ifixit [[Topic:Nikon D3200]] guide(s) for repairing your camera.
Here is a link to the ifixit [[Topic:Nikon D3200]] guide(s) for repairing your camera.
 
[[Topic:Nikon D3200]]
 
If this process seems too daunting, take your camera to a reputable, professional camera repair service and ask for a quote for a repair. If you decide to do this, ''do it sooner than later''.

현황:

open

원문 게시자: jayeff ,

텍스트:

Hi @ernieu717

As you know water and electronics and electricity are not a good mix.

''The impurities it the water causes corrosion and provides circuit paths for the electricity which were not in the camera's operating design and could damage the components.''

''First '''do not turn on your camera''' and then you need to '''remove the battery as soon as possible''' from the camera'' to minimize further damage.

Then you need to dis-assemble the rest of the camera and  clean ''all the affected parts'' using '''Isopropyl Alcohol 90%+''' (available from electronics parts stores) to remove all traces of corrosion and water. Do not use "rubbing alcohol" as in some cases this is only 70% IPA or less, can contain scents and is not as effective. If you do have to use it check the label to verify the  amount of IPA

Here is a link that describes the process.

[[Electronics Water Damage]]

As always with electronics, especially surface mounted PCBs be gentle when handling and especially when brushing away the corrosion. You do not want to remove any components from the board.

Hopefully after you have done all this the camera ''might'' possibly work correctly again.

Here is a link to the ifixit guide(s) for repairing your camera.

[[Topic:Nikon D3200]]

If this process seems too daunting, take your camera to a reputable, professional camera repair service and ask for a quote for a repair. If you decide to do this, ''do it sooner than later''.

현황:

open