주요 콘텐츠로 건너뛰기
도움말

원문 게시자: Charles Fryer ,

텍스트:

No, but I modified the tip of the lower latch itself by adding some 2 or 3 layers of duct tape.  Not the most elegant solution, but it works for quite a while before the tape gets worn and needs to be renewed.  A properly trimmed and mounted strip of tin can would be more permanent . . . either applied to the tip of the latch or, preferably, glued to the worn portion of the latch board.

Also bought a couple dozen fuses from China.  Cheap.  If a little too short, just carefully bend in the fuse mounting brackets.  The control board slides onto slots (as you know) and doesn’t need to be screwed in.  Same with the upper plastic piece over the door.  Same with the shield in front of the fuse.  As a result - AFTER UNPLUGGING - I can replace a blown fuse in about two minutes without tools.

Long term solution?  Avoid GE microwaves in the future.  Cheap, shoddy and rickety . . . plus replacement parts are exorbitant.  Classic modern planned obsolescence.

Oh, and don’t use Goof Off to clean tape residue off the control panel.  It reacts with and clouds the plastic.

현황:

open