주요 콘텐츠로 건너뛰기

기기를 수리하세요

수리할 권리

상점

도움말

현재 버전 게시자: jayeff ,

텍스트:

@Kevin Case
 
What is the make and model number of the washer?
 
If only the cold water, then there may be a problem with the cold water inlet solenoid valve, not closing properly when the power to it is disconnected.
 
The valves cannot be repaired they have to be replaced.
 
Knowing the make and model will help to find the correct part, because with some washers the valves come as a set i.e. both hot and cold inlet valves and with others they can be individually replaced.
 
Also check the mesh filters located in the hose fitting at the washer end of the hoses that supply the water to the machine. If it is damaged then any grit in the water supply can get in and this may lodge in the valve seat stopping it from fully closing. replacingReplacing the filter if damaged won’t fix the valve but may prevent it from happening again to the next one
Also check the mesh filters located in the hose fitting at the washer end of the hoses that supply the water to the machine. If it is damaged then any grit in the water supply can get in and this may lodge in the valve seat stopping it from fully closing. replacingReplacing the filter if damaged won’t fix the valve but may prevent it from happening again to the next one

현황:

open

편집자: jayeff ,

텍스트:

@Kevin Case
 
What is the make and model number of the washer?
 
If only the cold water, then there may be a problem with the cold water inlet solenoid valve, not closing properly when the power to it is disconnected.
 
The valves cannot be repaired they have to be replaced.
 
Knowing the make and model will help to find the correct part, because with some washers the valves come as a set i.e. both hot and cold inlet valves and with others they can be individually replaced.
 
Also check the mesh filters located in the hose fitting at the washer end of the hoses that supply the water to the machine. If it is damaged then any grit in the water supply can get in and this may lodge in the valve seat stopping it from fully closing. replacing the filter if damaged won’t fix the valve but may prevent it from happening again to the next one

현황:

open

원문 게시자: jayeff ,

텍스트:

@Kevin Case

What is the make and model number of the washer?

If only the cold water, then there may be a problem with the cold water inlet solenoid valve, not closing properly when the power to it is disconnected.

The valves cannot be repaired they have to be replaced.

Knowing the make and model will help to find the correct part, because with some washers the valves come as a set i.e. both hot and cold inlet valves and with others they can be individually replaced.

현황:

open