물건을 수리하세요 커뮤니티 상점
도움말

현재 버전 작성자: mike

텍스트:

-I suspect you either put on too much paste on (a common fault) or too little.
+I suspect you either put on too much paste (a common fault) or too little.
Also did you clean off all the old paste? I use isopropyl alcohol 99.8% pure to clean.
Remember what you are doing is filling in microscopic pits in the bottom of the heat sink and the top of the CPU. If any squishes out the side as you reinstall the heat sink you have used way too much!
So redo it and see how it goes.

현황:

open

편집자: Dan

텍스트:

-I suspect you either put on too much heat paste (a common fault) or too little.
+I suspect you either put on too much paste on (a common fault) or too little.
-Also did you clean off all the old paste? I use isopropyl alcohol 99.8% pure to clean
+Also did you clean off all the old paste? I use isopropyl alcohol 99.8% pure to clean.
-Remember what you are doing is filling in microscopic pits in the bottom of the heat sink and the top of the CPU. If any squishes out the side as you reinstall the heat sink you have used way too much.
+Remember what you are doing is filling in microscopic pits in the bottom of the heat sink and the top of the CPU. If any squishes out the side as you reinstall the heat sink you have used way too much!
So redo it and see how it goes.

현황:

open

원본 게시물 작성자: mike

텍스트:

I suspect you either put on too much heat paste (a common fault) or too little.

Also did you clean off all the old paste?  I use isopropyl alcohol 99.8% pure to clean

Remember what you are doing is filling in microscopic pits in the bottom of the heat sink and the top of the CPU. If any squishes out the side as you reinstall the heat sink you have used way too much.

So redo it and see how it goes.

현황:

open