주요 콘텐츠로 건너뛰기
도움말

현재 버전 게시자: Ben Eisenman ,

본문:

I would check 2 things:
* First, it sounds like your screen is not getting any data. Check the display data cable's connection to both the logic board (step 42 [guide|742|here]) and the LCD panel (following steps 45-60 [guide|984|here]: it's a different machine but the same process).
* {{{Edited as per Lemerise's correct info}}} The reed switch above the logic boardoptical drive is responsible for sleep function. Check to see if it was damaged or dislodged.
* {{{Edited as per Lemerise's correct info}}} The reed switch above the logic boardoptical drive is responsible for sleep function. Check to see if it was damaged or dislodged.
Good luck!

현황:

open

편집 작업: Ben Eisenman ,

본문:

I would check 2 things:
* First, it sounds like your screen is not getting any data. Check the display data cable's connection to both the logic board (step 42 [guide|742|here]) and the LCD panel (following steps 45-60 [guide|984|here]: it's a different machine but the same process).
* Also, It seems that{{{Edited as per Lemerise's correct info}}} The reed switch above the logic board is responsible for sleep magnet might have been jarred loose. It is located underneath the upper case, on the left side.function. Check to see if it was damaged or dislodged.
Good luck!
* Also, It seems that{{{Edited as per Lemerise's correct info}}} The reed switch above the logic board is responsible for sleep magnet might have been jarred loose. It is located underneath the upper case, on the left side.function. Check to see if it was damaged or dislodged.
Good luck!

현황:

open

편집 작업: Ben Eisenman ,

본문:

I would check 2 things:
* First, it sounds like your screen is not getting any data. Check the display data cable's connection to both the logic board (step 42 [guide|742|here]) and the LCD panel (following steps 45-60 [guide|984|here]guide|984|here]: it's a different machine but the same process).
* First, it sounds like your screen is not getting any data. Check the display data cable's connection to both the logic board (step 42 [guide|742|here]) and the LCD panel (following steps 45-60 [guide|984|here]guide|984|here]: it's a different machine but the same process).
* Also, It seems that the sleep magnet might have been jarred loose. It is located underneath the upper case, on the left side.

현황:

open

편집 작업: Ben Eisenman ,

본문:

I would check 2 things:
* First, it sounds like your screen is not getting any data. Check the display data cable's connection to both the logic board (step 42 [guide|742|here]) and the LCD panelpanel (following steps 45-60 [guide|984|here]).
* First, it sounds like your screen is not getting any data. Check the display data cable's connection to both the logic board (step 42 [guide|742|here]) and the LCD panelpanel (following steps 45-60 [guide|984|here]).
* Also, It seems that the sleep magnet might have been jarred loose. It is located underneath the upper case, on the left side.

현황:

open

원문 게시자: Ben Eisenman ,

본문:

I would check 2 things:
* First, it sounds like your screen is not getting any data. Check the display data cable's connection to both the logic board and the LCD panel.
* Also, It seems that the sleep magnet might have been jarred loose. It is located underneath the upper case, on the left side.

현황:

open