주요 콘텐츠로 건너뛰기

4세대 iPhone. 수리는 간단하지만 앞면 유리와 LCD를 하나의 유닛으로 교체해야 합니다. GSM / 8, 16 또는 32GB 용량 / Model A1332 / 검정 또는 흰색.

2375 질문 전체 보기

iPhone 4 screen is very sensitive to presure after a replacement

I can't get an answer to this question from anywhere. But after I replace a screen and put it all back together I boot the device and everything is good. Only if i put a little presure on the screen it has this color warp effect for a few seconds. As if the LCD is being squeezed. A factory iPhone does not do this. Is it cheap parts or is there a better reason? How can I avoid this?

이 질문에 답하기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

점수 -1
댓글 달기

답변 5개

A stupid question maybe, but did you remove the protective film on the back of the new display?

The most common cause of this issue is that the replacement glass is of poorer quality and a bit softer than the original, so it flexes when pressurized. This causes the back of the LED-display to get squeezed between the glass and the metal plate housing.

해당 답변은 도움이 되었습니까?

점수 0

댓글 1개:

That's what I was suspecting. I tried to be cheap and get the screens off eBay but for the most part they are garbage. Ill keep ordering from my good supplier. And I did remove the film!

댓글 달기

Who is your good supplier? I have the same problem.

해당 답변은 도움이 되었습니까?

점수 0

댓글 1개:

Who is your good supplier? I have the same problem.

댓글 달기

I have been having this issue also regardless of the supplier. I am thinking it has to do with adhesive thickness being to thin which allows the glass to rest directly on top of the LCD.

I don't know the specs but I am pretty sure there should be some clearance between th glass and LCD. Most likely measure in micro inches.

Thoughts?

해당 답변은 도움이 되었습니까?

점수 0
댓글 달기

You goons keep ripping off the foam between proximity and light sensor and blame others for your mistakes. Put a barrier between this two, so they won't interfere......problem solved.

해당 답변은 도움이 되었습니까?

점수 0
댓글 달기

Here is your problem right here .

Remove battery and removed all adesive holding the battery in place either on the frame and the battery itself.. Also make sure the battery has not been bent or dented when it was removed if so give it a little straighing up.. Now install battery and no more pressure marks..

The cause of this is when the back cover is replace and the battery it bent or adesives making the battery sit up further the back cover makes it press hard on the inside of the lcd

해당 답변은 도움이 되었습니까?

점수 0
댓글 달기

귀하의 답변을 추가하세요

Kris 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 0

전체 시간: 3,079