주요 콘텐츠로 건너뛰기

4세대 iPhone의 CDMA 버전. 수리는 간단하지만 앞면 유리와 LCD를 하나의 유닛으로 교체해야 합니다. 16 또는 32GB / Model A1349 / CDMA 호환성.

295 질문 전체 보기

Verizon iPhone Has Bad/No Signal Strength After Repair?

I recently have taken apart a friends iphone 4 to try to replace the front and top buttons because the top button was stuck and the front button seemed broken. Both fixes went well, but turning the phone on for the first time after fixing them brought upon another problem. Anywhere in either of our houses, there is no signal to verizon's 3g towers at all, and around our town there is little signal to this particular phone. I don't exactly know how this has happened because I've torn down three or four iphones before and re-assembled them correctly and they worked fine. I have read that there is a blue inductor coil on the GSM version that can be fixed with a silver conductive material on the motherboard, but I can't find anywhere that talks about a fix for the verizon iphone. It just keeps saying searching for service and keeps failing calls. Hopefully someone else can point me in the right direction! Thanks so much!

-Ryan

이 질문에 답하기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

점수 -1
댓글 달기

답변 1개

가장 유용한 답변

Try and check your connection to board. I have had this issue on a GSM, and saw that the connector bent, I had to straighten in and snap back in. Luckily It worked and I didn't need to order a replacement antenna. Also take note about contamination: "Before reassembly, be sure to clean all metal-to-metal contact points on the logic board (not the mating halves of connectors) with a de-greaser such as windex or isopropyl alcohol. The oils on your fingers have the potential to cause grounding issues."

-- I'm thinking in most cases the antenna is damaged, or just not fastened all the way.

Justin M.

해당 답변은 도움이 되었습니까?

점수 1

댓글 1개:

I think i've checked the connection for both of the antenna parts (bottom of the motherboard from the speaker assembly, and top right of the motherboard under the other shield near the audio jack) and they both seem pretty secure. I've even swapped out the speaker assembly with another iphone and still have had no luck getting a better signal. When you say "not the mating halves of the connectors" do you mean not the actual parts where the antenna cables meet with the motherboard? I have cleaned those parts with isopropyl alcohol, but not any other part on the motherboard. Are there any other spots on it you would recommend cleaning that might interfere with the signal? Could I have made it worse by cleaning the actual contact points of the antennas?

Thanks so much for your response!

-Ryan

댓글 달기

귀하의 답변을 추가하세요

Ryan 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 0

전체 시간: 1,427