Can you replace the battery without soldering?

Question

iPhone 1st Generation

첫 번째 iPhone 모델, Model A1203은 4, 8, 또는 16GB 용량과 알루미늄 뒷면을 가지고 있습니다. 수리를 하려면 상당한 양의 비집기와 납땜을 요구할 수 있습니다.

224 질문 전체 보기

madmaxmedia @madmaxmedia

평판: 159

5

2

게시일: 2009년 12월 11일

옵션

Can you replace the battery without soldering?

Is there room in the iPhone to simply cut the old wires, strip the end, and then attach the leads to the replacement battery wires? (of course using some heat shrink tubing to insulate the connections.) It shouldn't take up that much extra space, if you judge the lengths correctly. Judging by the photos here, I think there should be enough room.

I read so much about the difficulties of desoldering and soldering on the iPhone board, thought this might be a safer route. Of course, you still need to be careful not to cause a short, etc.

이 질문에 답하기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

예 아니요

점수 -1

댓글 달기

답변 3개

madmaxmedia @madmaxmedia 평판: 159 5 2 · Answer 1 · 2009-12-17T20:31:28-07:00

가장 유용한 답변

madmaxmedia @madmaxmedia

평판: 159

5

2

게시일: 2009년 12월 17일

옵션

LOL, thanks Louis. I have soldered little connections before, but had read about how difficult this one was- I guess that's all relative. I've done enough iFixit repairs to know I can handle most difficult jobs, but also that I'm better off to take the easiest way possible... ;-)

해당 답변은 도움이 되었습니까?

예 아니요

점수 1

댓글 달기

Ben Eisenman @beneisenman 평판: 87.6k 161 82 213 · Answer 2 · 2009-12-11T17:16:25-07:00

Ben Eisenman @beneisenman

평판: 87.6k

161

82

213

게시일: 2009년 12월 11일

옵션

I'm not an expert on soldering, but it seems to me that doing it that way, while it may be easier, creates 3 possible failure points instead of 2 (battery side, logic board side, and then adding a middle solder). With something that gets bumped around that much, it seems scary to me.

Having that said, I believe there may be enough clearance.. steps 18-21 of the guide show sufficient wire length.

해당 답변은 도움이 되었습니까?

예 아니요

점수 0

댓글 달기