기기를 수리하세요 커뮤니티 상점

Apple iPhone 5c는 2013년 9월 10일에 발표되었습니다. 수리는 이전 모델과 유사하며 스크류 드라이버 및 비집는 도구가 필요합니다. GSM 또는 CDMA / 8, 16, 32GB / 흰색, 분홍색, 노란색, 파란색 및 녹색으로 제공하였습니다.

1233 질문 전체 보기
질문 마감됨

옵션

Digitizer not responding after replacing with working screen/digitizer

Hi peeps,

I have received one iphone 5c which powers up, but doesn't respond when swiping to unlock.

I have another iphone 5c that has a working screen/digitizer, so I've taken this and replaced it with the non-responsive one. Same issue occurs - can't swipe to unlock.

Does anyone have any idea as to what could be causing this? Could it be a duff connector on the main board?

I'm pretty sure the phone may have been water damaged.

이 질문에 답하기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

예 아니요
점수 0

댓글 1개:

Anyone?... Anyone?... Bueller?

의

댓글 달기

답변 3개

필터:
가장 유용함 가장 최근 가장 오래된

옵션

It is likely a board level issue, maybe a short or an issue with the U3. The digitizer connector would usually still allow the touchscreen to have limited responsiveness.

해당 답변은 도움이 되었습니까?

예 아니요
점수 0
댓글 달기

옵션

Dave C , this can be caused by a bad digitizer connector. As you can see the connector lacks metal ends and this is what makes it a weak connector. It is easily possible to damage the connector by mis-aligning the digitizer connector

Block Image

Block Image

like this. Check the ends of the connector. The plastic of the connector has been compressed into the connector, causing it to flare out and preventing from making proper contact.

해당 답변은 도움이 되었습니까?

예 아니요
점수 0
댓글 달기

옵션

I ended up fixing this in the end.

All it needed was a couple of minutes in the ultrasonic cleaner and and good brush with IPA.

I'm pretty sure it was the contacts on the board that were the problem.

Thanks for your suggestions

해당 답변은 도움이 되었습니까?

예 아니요
점수 0
댓글 달기
조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 0

전체 시간: 151