주요 콘텐츠로 건너뛰기

2015년 9월 25일 출시. Model A1687/A1634. 수리는 이전 모델과 유사하며 스크류 드라이버 및 비집는 도구가 필요합니다. GSM 또는 CDMA / 6, 64, 또는 128GB / 은색, 금색, 스페이스 그레이 및 로즈 골드로 제공하였습니다.

1041 질문 전체 보기
질문 마감됨

Front camera or earpiece don't work

Hello,

I changed the logo on my iphone 6s pls to liht up, but after i assembled everything works great but now the earpiece or front facing camera do not work. The proximity sensor does work when i hover over the screen it does go black in a call but i cannot hear anyone.

I am really not sure what happened but I did do a dfu restore and still no avail on fixing it. Is it possible the flex cable for the camera and ear piece has been shorted out needing to be replaced? I really am hoping I didn't damage a component on the logic board, but I did not touch any of the components when installing this led light mod.

이 질문에 답하기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

점수 0
댓글 1개

Anyone have an answer to this post?

댓글 달기

답변 1개

가장 유용한 답변

First off, that's a pretty heavy mod for a non-professional. You should be impressed with yourself despite the camera/earspeaker problem! I think what most likely happened is that the flex cable that holds those two and the proximity sensor probably got knicked. Just in case though, remove the screen again (ALWAYS disconnect the battery from the board before touching anything else), and take a look at the FPC connector on the motherboard where that flex cable plugs in under a microscope. It's the bottom one of the three horizontals. Confirm that all the pins are present and straight. Before you reconnect the screen, make sure all the connectors are flat on the end of the flexes. They have a tendency to bow and lose connection. If you have more questions just respond, I'll be glad to help

해당 답변은 도움이 되었습니까?

점수 1

댓글 1개:

i've done many of these mods before and didn;t do this. I did make sure but i believe it was shorted out by the light mod. the connector was not touched when doing this light mod

댓글 달기
조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 0

전체 시간: 150