주요 콘텐츠로 건너뛰기

Apple iPhone 5s는 2013년 9월 10일에 발표되었습니다. 수리는 이전 모델과 유사하며 스크류 드라이버 및 비집는 도구가 필요합니다. GSM 또는 CDMA / 16, 32, 또는 64GB / 은색, 금색 및 스페이스 그레이.

3530 질문 전체 보기

Why isn't my iPhone charging after a (store done) battery replacement?

My Iphone 6 plus was stolen on the weekend so i have changed back to my old 5S. i had to get the screen fixed and once i did that i realised how short of a life span the battery had, so i went back and got the battery replaced. It was 100% charged and was working fine until about 2 hours later it died and asked me to plug into a power source. I have been doing that for the last 2 hours but the empty battery with the red stripe is still on the screen.

PLEASE HELP

답변되었습니다! 답변 보기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

점수 0
댓글 달기

답변 2개

선택된 답변

Either battery not plugged in properly or faulty battery. I would go back to the store if I was you. Check the charging port first if you have any blockage in there. If there is, use a toothpick to clean it out. You can confirm blockage if the charging cable does not plug fully plug into the port.

해당 답변은 도움이 되었습니까?

점수 2
댓글 달기

Even though the battery read 100% when you received it from the store, it still might not have been actually charged up 100%. So if the store changes your battery again you still should put it on the charger the first chance you get and let it charge for at least 24 hours before starting regular usage and then always let the unit run till it runs out of power and then charge it again from low power. And never put the unit on the charger until it is low power. Many rechargeable batteries if you charge then when they have a high charge retain a memory and once they are plugged into a charging device for their first year of service think that they are low when they actually aren't. So best to only charge the battery when it says it is low on power only.

해당 답변은 도움이 되었습니까?

점수 1

댓글 1개:

Definitely worth trying this. Some new battery's may start with a very low voltage such as 1.2V instead of the usual 3.7v for low battery for example. This is why it may take like 24 hours to get it back to the normal voltage range of 3.7-4.2v.

댓글 달기

귀하의 답변을 추가하세요

juliabasell 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 1

30일 전: 1

전체 시간: 84