기기를 수리하세요 커뮤니티 상점

Samsung Galaxy Note II는 대형 스크린과 필수 자체-저장 스타일러스로 최적화된 소프트웨어가 결합한 스마트폰입니다.

211 질문 전체 보기

옵션

After replaceing glass - touch doesn't work very well

Hi,

I've replaced my cracked glass on the Galaxy Note II and everything works well.

However, I can see that the glass is a bit higher than the metal body in the lower part (near the buttons) and the touch isn't working very well in these areas. If I press the glass down hard, it stays there and the touch is working fine then, but after a few minutes it rises up again and the touch doesn't work well (still works, but stutters).

I think it might be because some adhesive was left on the adhesive tape surrounding the body... or maybe while removing the glass, I pulled the LCD up too much...

Do I need to redo the whole procedure?

I even tried keeping the phone under a heavy weight throughout the night but even that didn't work.

Please help!

Amit

이 질문에 답하기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

예 아니요
점수 -1
댓글 달기

답변 1개

필터:
가장 유용함 가장 최근 가장 오래된
가장 유용한 답변

옵션

This is most likely due to the previous old adhesive for the old glass not being cleaned on the frame properly and/or newly applied adhesive was too thick causing the touch to be too high and not work properly unless pressed down hard.

I think you need to clean the adhesive very well on the frame then put new adhesive on again. I haven't done glass replacement on the Samsung Galaxy Note II so there may be other things you need to do to get it working reliably.

해당 답변은 도움이 되었습니까?

예 아니요
점수 1

댓글 2개:

Thanks for replying!

So do I need to buy a new glass? If I remove the glass and I want to put it on again, where do I get new adhesive from?

의

댓글 달기

귀하의 답변을 추가하세요

Amit 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 0

전체 시간: 64