주요 콘텐츠로 건너뛰기

2015년 9월 25일 출시. Model A1688/A1633. 수리는 이전 모델과 유사하며 스크류 드라이버 및 비집는 도구가 필요합니다. GSM 또는 CDMA / 6, 64, 또는 128GB / 은색, 금색, 스페이스 그레이 및 로즈 골드로 제공하였습니다.

2688 질문 전체 보기

iPhone 6s died after a night charge

Yesterday a cumstomer brought a dead iPhone 6s after a night charge, the phone is only 4 months old and apple refuse to accept the phone for a repair or swap.

I advised her to contact Apple customer service, since the phone is only 4 months old.

She told me that she’s no longer wanted to return the phone to the Apple store, because how they treated there customers.

Before I explain the problem, the phone has never been opened before and not touch with water.

I opend the phone and I start with test the battery with the multimeter. I find out that there is no voltage anymore on the original battery.I replace the battery for a new OEM Battery and the phone turns on again ☺, but he didn’t pass the apple logo. The phone stays on and only shows the apple logo.I connect the phone to Itunes and try restore the phone with recovery mode and dfu mode, I get the message error 6. I open the phone again and disconnect the rear camera and proximity sensor and try to restore again with no lock. I try different original apple usb cable and difference usb ports but with no luck.

I think there’s a broken component on the motherboard that need to be replace, but I don’t know where I need to start.

Can someone help me with this problem?

By the Way sorry for my bad English.

Best regards,

Marvin

답변되었습니다! 답변 보기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

점수 1
댓글 2개

Did you try another battery? The replacement battery quality is so bad in the market. Also, the replacement battery may need time to charge up depending on how low it was when you installed it. A bad battery has been the culprit for a Apple logo sticking or a boot loop, in the past.

Yes I try 3 differents batteries

댓글 달기

답변 1개

선택된 답변

I'm starting to wonder if there's a soldering connection that needs to be reflowed. Particularly on the u2ic

해당 답변은 도움이 되었습니까?

점수 1

댓글 4개:

if it's the u2ic the phone still need to boot when the battery is not empty right?

Yeh. The u2ic helps the battery charge. No u2ic. No power to battery

I think it's the u2ic. I heat little bit the u2ic with the hot air and the phone charge again for 2 minutes, after that the phone doesn't charge again. For now i don't change the u2ic because I don't have enough skill on this moment.

Skill and good tools are a big necessity

댓글 달기

귀하의 답변을 추가하세요

Marvin 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 0

전체 시간: 854