기기를 수리하세요 커뮤니티 상점

2012년 9월 12일에 발표된 여섯 번째 Apple iPhone입니다. 수리는 이전 모델과 유사하며 스크류 드라이버 및 비집는 도구가 필요합니다. GSM 또는 CDMA / 16, 32, 또는 64GB / 검정색 또는 흰색으로 제공하였습니다.

2522 질문 전체 보기

옵션

Why the device doesn't turn on with the new display assembly?

After the display assembly replacement, the device doesn't turn on, but only shows (full screen) the battery (as if it would be out of charge) and the lightning plug icons.

Once I plug it in, only the battery icons remain, and if I disconnect the battery (while the plug is in) it shows the apple logo for a few seconds and then gets shuted down.

Is there something I could try before contact the vendor asking for the replacement?

Thank you all ^^

답변되었습니다! 답변 보기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

예 아니요
점수 1
댓글 달기

답변 2개

필터:
가장 유용함 가장 최근 가장 오래된
선택된 답변

옵션

Try disconnecting the battery and reconnecting it again after a few seconds. I had a similar problem and this worked for me.

해당 답변은 도움이 되었습니까?

예 아니요
점수 1

댓글 3개:

Thank you Klaus :) it tooks me a bit more than a few seconds, but it finally works!

I also had to keep it under charge for a few minutes (as suggested by the support).

Btw, thank you again!

의

Yeah, usually this means battery is flat or bad contact with both the battery connector and the battery ribbon cable plug itself, replugging it solves this issue most of the time.

의

You're very welcome, glad it worked:)

의

댓글 달기

옵션

Usually there are 5 possible reasons for the problem:

1. Power Distribution Issue

2. The Dead Battery Issue

3. The Damage Board Issue

4. Assembly Issue

5. Problem with Flat Cable Connection

You can find more details here: What to Do When iPhone Won't Turn on after Screen Replacement

해당 답변은 도움이 되었습니까?

예 아니요
점수 0

댓글 1개:

Sorry, but I can't follow the link.....just says 404

의

댓글 달기

귀하의 답변을 추가하세요

Rocco Lorusso 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 1

7일 전: 8

30일 전: 10

전체 시간: 106