평판: 21
2
3
Hey, today I replaced the screen of an iPad Air 2. Now the screen stays black even if I try it with the old LCD screen and digitizer. The iPad was not powered on when I replaced the screen. So I think it's not the backlight.
iTunes recognizes the iPad... Any ideas?
좋은 질문 입니까?
평판: 159.7k
11
191
368
If I'm correct you can lift up the battery connector after unscrewing the battery without taking the logic board out.
Anyway try holding the power and reset button for 15 seconds and try turning it on again.
해당 답변은 도움이 되었습니까?
24 시간 전: 0
7일 전: 0
30일 전: 0
전체 시간: 673
댓글 2개
Did you unplug the battery before unplugging and plugging in the lcd and Digitizer cable?
Ben 의
No. Could this help maybe? I would have to remove the logic board. Not sure if this is an good idea ^^
elreparero 의