주요 콘텐츠로 건너뛰기

모델 A1297 Unibody: 2009 상반기, 2009 중반기, 2010 중반기, 2011 상반기 & 2011 하반기

544 질문 전체 보기

New Battery not recognized? Bad new battery?

I replaced my battery per iFixit guide, but my Magsafe light shows no charging (stays green) , and my Battery Status menu says "No Battery Available".

Do I have a bad battery? Are there any DIY ways to test it?

Is there a step missing from install? Help?

Update (08/19/2016)

Status images from Coconut Battery and System Profiler.

Block Image

corrected image below.

Block Image

답변되었습니다! 답변 보기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

점수 0
댓글 3개

Was the mag-safe light working on the swollen battery?

Thanks for the reply. Somehow missed notification. Magsafe was/is working, but shows Green and power menu says "power source: power adaptor". I was expecting Yellow for charging, but it's still not seeing the battery after being plugged in all night.

images added above

댓글 달기

답변 2개

선택된 답변

Download and run Coconut battery to get a better idea of what's going on with the battery. Let us know your results. You did answer about the swollen one. http://www.coconut-flavour.com/coconutba...

해당 답변은 도움이 되었습니까?

점수 2

댓글 7개:

images added to original. not sure if it notifies you, so I am commenting here.

thanks

On the Coconut Battery, run it again and get the information on the battery and post it, not the page about the machine.

The bottom half of that IS the battery info, but I'll doublecheck.

There are two boxes, one says Mac details the one to the right of it says battery details.

fixed above, i stand corrected.

댓글 2개 더보기

댓글 달기

What caused the battery to be replaced? There is battery management system that detects the voltage and control the charging system. I cannot give you exact solution unless there is some more information. I assume it might have some liquid contact to have the battery circuit to become like that or try to unplug the battery and the magsafe.

After the computer is off without any power source, push the power button once.

1) Push down the power button

2) Connect the magsafe

3) Release the power button after 10 seconds let the system boot in high fan.

4) Shut it off and unplug the power source

5)Connect the battery and plug in the charger

Lets see if it works. I might take a while to get back to the answer but that is a simple way to test or diagnose if there is no liquid contact.

해당 답변은 도움이 되었습니까?

점수 0

댓글 2개:

The old battery swelled up in the space directly under the trackpad. I bought a new legit same spec replacement battery.

see fixed image above as well.

I will try suggested steps tonight. thanks

I tried this with no luck. The results are unchanged.

I reconnected the old battery and it works fine, so the connector on the MBP is fine.

댓글 달기

귀하의 답변을 추가하세요

scottbernardis 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 0

전체 시간: 491