기기를 수리하세요 커뮤니티 상점

Apple iPhone 5s는 2013년 9월 10일에 발표되었습니다. 수리는 이전 모델과 유사하며 스크류 드라이버 및 비집는 도구가 필요합니다. GSM 또는 CDMA / 16, 32, 또는 64GB / 은색, 금색 및 스페이스 그레이.

3530 질문 전체 보기

옵션

Won't turn back on

I took the iPhone 5s apart to clean some fluff from the rear camera but after reassembling it won't turn on. When I took it apart the first time it was stuck then suddenly opened and the home button flex cable connector and metal clip came off but it didn't look damaged. I've since replaced the home button and flex cable but it's still not turning on. Any suggestions ?

Update (01/07/2017)

Thanks

I've not got another battery but when I connect it to a PC iTunes starts and says can't connect to iPhone because it locked but nothing on the phone display

이 질문에 답하기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

예 아니요
점수 0
댓글 달기

답변 3개

필터:
가장 유용함 가장 최근 가장 오래된

옵션

Try swapping in a known good battery and charging port if you can get access to one. Then try plugging it into iTunes, if it turns on perfectly fine, then narrow it down to one part. If it doesn't connect to iTunes, your board is most likely bad.

해당 답변은 도움이 되었습니까?

예 아니요
점수 0
댓글 달기

옵션

You have shorted the anode filter bead on the backlight circuit. A local repairer can fix this easy. Always remove the battery 1st!

해당 답변은 도움이 되었습니까?

예 아니요
점수 0

댓글 2개:

I suppose it's possible that I could have shorted some pins when re-attaching the 3 connectors on the top right while the battery was still connected, not my best move! I'm not sure if you can damage a filter cap by shorting it?

Is the backlight circuit on the logic board or the display?

의

hi Melfyn.

i can say for 100% on the 5s that the anode emi filter bead is blown. this is only a small part and is a quick fix for any repair technician. on the 5s the backlight driver ic , coil and diode rarely fail even when shorted. the filter bead is just below the lcd connector socket on the logic board

의

댓글 달기

옵션

Backlight ic is on the logic board, but if you are lucky and the ic isn't damage then a new screen will fix the problem, don't forget to disconnect the battery first and place the screws in the correct order ( to prevent damage the logic board ) on the metal plate that covers the 3 connectors of the screen.

Sorry for my poor English.

해당 답변은 도움이 되었습니까?

예 아니요
점수 0

댓글 2개:

Would this prevent the phone from switching on or just the display working? There's no vibration when I switch the silent switch on/off.

의

thats is why you dont see a image on the screen, when you take a torch and view from a angle may you can see the image.

의

댓글 달기

귀하의 답변을 추가하세요

Melfyn Edwards 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 0

전체 시간: 92