기기를 수리하세요 커뮤니티 상점

2015년 9월 25일 출시. Model A1688/A1633. 수리는 이전 모델과 유사하며 스크류 드라이버 및 비집는 도구가 필요합니다. GSM 또는 CDMA / 6, 64, 또는 128GB / 은색, 금색, 스페이스 그레이 및 로즈 골드로 제공하였습니다.

2688 질문 전체 보기

옵션

iPhone fell in pool

Hey guys. I submerged my iPhone 6s about two weeks ago in a pool (for not even 5 seconds). As soon as I realized it I took it out of its case and shook out water and let it air dry (hot, non humid weather). The phone worked fine that entire afternoon until the evening when streaks displayed on the screen. I now know I should've powered it off but I didn't know that then. I also did not have access to tools to open it and let it dry better. The following morning it was off. And has been off since. A couple of days ago we returned fr vacation and I finally opened the phone. Nothing seems rusty or corroded. Any suggestions? I'm thinking it's most likely the screen that needs to be replaced. My husband said that the other day he connected it, he felt it vibrate but of course nothing displayed on the screen. What should be my next step?

답변되었습니다! 답변 보기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

예 아니요
점수 2
댓글 달기

답변 3개

필터:
가장 유용함 가장 최근 가장 오래된
선택된 답변

옵션

Clean the board with 90% isopropyl alcohol and a toothbrush. Try to get the shields off, if you can then just brush what you can. Replace the battery and bring it to a electronics repair place that can get the shields off if you can't. After the board is all clean put it back in and try to fire it up. If it doesn't, send it somewhere. If it does, test everything and make sure it works.

해당 답변은 도움이 되었습니까?

예 아니요
점수 2
댓글 달기

옵션

its just water on the backlight. I don't know what everyone else is going on about.

You can replace the display, but you can also replace the backlight.

해당 답변은 도움이 되었습니까?

예 아니요
점수 2
댓글 달기

옵션

I would send the phone to a company that is qualified to clean the oxidation off of the components and replace any that may be shorted, oxidated or otherwise damaged.

The reason that I suggest that route rather than just order a screen is so that you don't throw money into the phone without knowing what is going on. Opening the phone and looking around is a good first step. The logic board needs to be removed and cleaned. Most of the water damage that I have seen is on the backside of the logic board. This is because most of us set the phone down screen side up. This causes the water that did get into the phone to go to the lowest spot, the backside of the components.

Disassemble, inspect, replace bad components, clean, re-assemble. Most shops that can do component level repair and data recovery will have a screen to verify whether or not yours is damaged.

해당 답변은 도움이 되었습니까?

예 아니요
점수 0

댓글 2개:

Thank you. That's so true! I have no idea where to turn. I'm struggling to find someone locally. :/

의

Where is local ?

의

댓글 달기

귀하의 답변을 추가하세요

sophia 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 2

전체 시간: 2,551