2014년 9월 19일에 출시된 이 5.5” 스크린 iPhone은 iPhone 6의 큰 버전입니다.

1387 질문 전체 보기

USB Not working after screen replacement

Hi all!

I replaced the screen on my iPhone 6 plus and just when starting it I noticed the boot was extremely slow, like 10 minutes just to have the phone running again, then now in the home screen I see the touch id is not working (the new screen has it) and also the phone isn't charging and If I put it on DFU mode and connect it to PC or MAC them will not detect the phone

The unique way to have the phone charging is to leave it discharge to dead (0%) and plug it, it will charge until 2%, will automatically start and that's it, it will not charge any more

Any idea what can i do?

답변되었습니다! View the answer 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

점수 0
의견 추가하세요

US$100 이상 또는 Pro Tech Toolkit을 포함한 모든 주문의 배송은 무료입니다!

상점 둘러보기

1개의 답변

선택된 해법

I assume the phone worked properly before you did the screen replacement.

Did you follow this guide? Of particular importance is Step 12. Notice how the screws are of different lengths? There is only 0.3mm difference between the short ones and the next closest.

If you mixed up those screws, you may have damaged the logic board. This is commonly called Long-Screw Damage.

This is what I fear in your case.

Of course, depending on if you used heat or not on the device to open (not necessary), there may be other logic board problems such as U2/Tristar (it communicates with the Lightning Port and "talks" with certified chargers).

So go back through the steps of the guide and let us know if everything was done properly. You will probably need to find an experienced micro-soldering repair shop to fix this.

해당 답변은 도움이 되었습니까?

점수 1
의견 추가하세요

귀하의 답변을 추가하십시오

Jose Restrepo 가/이 대단히 고마워 할 것입니다.
조회 통계:

지난 24시간: 0

지난 7일: 0

지난 30일: 0

전체 시간: 66