주요 콘텐츠로 건너뛰기

2014년 9월 19일에 출시된 이 4.7” 스크린 iPhone은 iPhone 6 Plus의 작은 버전입니다. 모델 번호 A1549, A1586 및 A1589로 식별됩니다.

4994 질문 전체 보기

Phone earpiece and headphone jack nonfunctional

Before you say it, my phone is not stuck in headphone mode. The volume overlay clearly shows when the headphone volume is being effected vs. the ringer/speaker volume. I also tried a myriad of things to get it resolved from suggestions on the Internet.

Without any success, I swapped out the Lightning Connector Assembly and didn't run into any problems thanks to the resources on this site (Thank You!). Even with the new assembly, neither the earpiece nor the headphone jack work. The lightning port works fine as well as the loud speaker. So, nothing's changed.

I checked every connection over several times. Everything clicked in with a snap. Can't find anything wrong. All the connectors look clean, no pins bent. So, I'm guessing it's the Logic Board.

Anyone have any other ideas or suggestions? Much appreciated!!

Rick

이 질문에 답하기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

점수 0
댓글 달기

답변 1개

가장 유용한 답변

Under your earpiece should be a piece of black tape that covers up some gold contacts for an antenna. I believe it's the wifi antenna. I had an issue with a customer where the black tape was missing which caused it to ground out. As far as the headphone jack goes, I know it's strange that you are having the exact same issue, but I'd try one more head phone jack/lightning cable assembly. This time connect it externally by just connecting the cable to the motherboard. Put a piece of paper under it so it doesnt ground out on the case or any other metal and see if that helps. If it does work, then the assembly is grounding out within the case when installed somewhere.

해당 답변은 도움이 되었습니까?

점수 1

댓글 3개:

Funny you should mention that because when I first took the screen off, I noticed that little sticky cover had slid down below the gold contact. I peeled it off and put it back where it belonged. I double checked to make sure it was completely covered. Good thinking, but wasn't the problem. Thank you.

Im hoping it's not some strange board issue, but it's possible at this point that it could be. You may want to search for reputable board level repair companies at this point to see if there is an IC that needs replacing.

Thanks Brian, that's exactly what I did. I'll know in a cpl days and post the outcome. I appreciate all of your input.

댓글 달기

귀하의 답변을 추가하세요

Rick 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 0

전체 시간: 64