주요 콘텐츠로 건너뛰기

2015년 9월 25일 출시. Model A1688/A1633. 수리는 이전 모델과 유사하며 스크류 드라이버 및 비집는 도구가 필요합니다. GSM 또는 CDMA / 6, 64, 또는 128GB / 은색, 금색, 스페이스 그레이 및 로즈 골드로 제공하였습니다.

2690 질문 전체 보기

Not able to use Cell service but wifi & bluetooth are fine

This iphone 6s is switching rapidly (within a min) from full bars at&t to 1 bar to no service to full service to 2 bars and so on whenever i try to make a call it immediately says call failed.

I put in a new charge port so then i did the repair again and put in a second new charge port but still no change so then i put in a new antenna cable, the one that runs along side the logic board and adheres to the speaker and still it did the same thing, have reset network flipped between airplane mode and so on

Any suggestions??

답변되었습니다! 답변 보기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

점수 0
댓글 1개

Try a different sim card

댓글 달기

답변 1개

선택된 답변

Try taking out SIM card from slot on right side of the phone(check the SIM card for crud that might be interfering with the SIM card contacts. Clean it with a DRY toothbrush.) , putting the phone in airplane mode, and putting the SIM card back in. Then turn airplane mode off. If that does not work, take out the SIM card again, and restart the phone, and put the SIM card back in. If that does not work, force restart your phone by holding the power and home buttons at the same time until the Phone restarts. Do this last step with the SIM card in.

Only by last resort should you replace the antenna. Hope I could help.

-a novice

해당 답변은 도움이 되었습니까?

점수 0
댓글 달기

귀하의 답변을 추가하세요

Deborah 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 0

전체 시간: 59