iPhone 6 won't turn on after water damage clear up

Question

iPhone 6

2014년 9월 19일에 출시된 이 4.7” 스크린 iPhone은 iPhone 6 Plus의 작은 버전입니다. 모델 번호 A1549, A1586 및 A1589로 식별됩니다.

4994 질문 전체 보기

Felipe Kashiwagura @felipeksw

평판: 1

1

게시일: 2017년 8월 3일

옵션

iPhone 6 won't turn on after water damage clear up

Hi ifixit family!

The iPhone 6 dropped in a water and won't turn on anymore. I checked and remove the capacitor C5202_RF (smoked/sorted). In this process, unfortunately, I broken the resistor R5201_RF. But after this this iPhone turn on (power supply shows 0A when tunr off)... I tested the basic functions (digitizer, LCD, sim card slot) and were OK.

Checking the board I saw some "oxidation" on LCD connector and near of baseband shield, so I removed the baseband shield and the other side shield and put the logic board in UltraSonic Cleaner whit 99.9% Isopropanol . After 2 cicles of 10 minutes I brushed the board (ESD safe brush).

For my surprise after the clear up process the board won't turn on. The power supply shows 0A and when I press power button the iPhone won't turn on and the power supply still 0A.

Suggestions for look up the board problem?

Thanks and sorry my bad english

Felipe

이 질문에 답하기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

예 아니요

점수 0

댓글 달기

답변 3개

Jacob Miller @thefix0702 평판: 421 The Fix Electronix 5 1 · Answer 1 · 2017-08-03T08:24:55-07:00

가장 유용한 답변

Jacob Miller @thefix0702

평판: 421

The Fix Electronix

5

1

게시일: 2017년 8월 3일

옵션

You need to use actual electronic cleaner in your ultrasonic cleaner (like Branson EC with DISTILLED water). I follow the treatment with a soak in 100% isopropyl alchohol to remove any residual moisture. Then dry it (i use a toaster oven heated to 212f . The most important part is using the correct solution in your cleaner. Alchohol is great for degreasing and flux clean up but won't fully dissolve any water corrosion or oxidation deep underneath SMD chips, etc.

해당 답변은 도움이 되었습니까?

예 아니요

점수 1

댓글 달기