주요 콘텐츠로 건너뛰기

2015년 9월 25일 출시. Model A1687/A1634. 수리는 이전 모델과 유사하며 스크류 드라이버 및 비집는 도구가 필요합니다. GSM 또는 CDMA / 6, 64, 또는 128GB / 은색, 금색, 스페이스 그레이 및 로즈 골드로 제공하였습니다.

1041 질문 전체 보기

Why wont my screen turn on after lcd replacement

Hey guys ! I recently changed the screen to my moms iPhone 6s plus because it was completely shattered. At first with the broken screen it would have turn on but you couldn't seen anything (if that makes sense). Now with the new screen the phone itself is on but no picture shows with the new screen , like you can hear the lock of the phone when you unlock it with your finger and the alarm on it went off . I don't know what to do HELP !!!!

답변되었습니다! 답변 보기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

점수 0
댓글 2개

@gmej1 you disconnected the battery before replacing the display?

@oldturkey03 no I didn't I just replaced it normally

댓글 달기

답변 2개

선택된 답변

It is possible that the new LCD could have been a DOA and would have to have it swapped out for a working one or it could be that not all the pins have been connected and all seated correctly and fully. Try opening it back up and make sure all are in place. Could be a possibility that a single little pin could have gotten bent and therefor it does not work.

해당 답변은 도움이 되었습니까?

점수 4
댓글 달기

@gmej1 this is one of those cases where you may have blown the backlight filter. Check FL4211. On the 6S Plus, the power is constant, regardless of whether the screen is on or off. So replacing it with the battery connected may causes damage to the filter which is part of the power line which supplies power to the screen.

해당 답변은 도움이 되었습니까?

점수 2
댓글 달기

귀하의 답변을 추가하세요

Genecis mejia-perez 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 0

전체 시간: 92