주요 콘텐츠로 건너뛰기

2015년 9월 25일 출시. Model A1688/A1633. 수리는 이전 모델과 유사하며 스크류 드라이버 및 비집는 도구가 필요합니다. GSM 또는 CDMA / 6, 64, 또는 128GB / 은색, 금색, 스페이스 그레이 및 로즈 골드로 제공하였습니다.

2688 질문 전체 보기

Won't let me end calls

Hi my IPhone 6s has a problem where if I make a call the screen goes black, if I press the home button the screen come back on shortly but it won't let me end the call with the red end call on screen. I have to reset by holding down the power button and home. Everything else seems to work ok.

답변되었습니다! 답변 보기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

점수 5
댓글 달기

답변 4개

선택된 답변

Sounds like you have a proximity sensor problem! How long have you had this phone? Did you buy it new or used? Has the screen been changed on it?

I believe the sensor to detect if it is up to your ear is out of position and always detecting something in front of it. Solutions could be to align the sensor correctly, or if the assembly is bad, to replace it.

Good luck!

해당 답변은 도움이 되었습니까?

점수 1

댓글 6개:

Hi it was the third party screen that's the problem, any idea why it would do this ? Any fix?

That can be common - Did the replacement screen come with the front camera and speaker installed? It is not un common for the sensor to be aligned poorly, or there is a possibility that the sensor assembly is defective.

Some things you can try- if you are curious enough

Remove the front camera lightsenor/prox flex cable, and test it off of the screen with your finger - to see if it activates. You might need 3 hands to do this though! and do be careful not to put any stress on the ribbons/connectors or you could cause some pretty serious damage.

If it works - then it was most likely an alignment issue and the sensor is blocked by the screen

If it doesn't work, then it is a faulty front camera flex

Here is a walk through on how to take the flex assembly out.

iPhone 6s 전면 카메라 및 센서 어셈블리

And here is a new one if yours is bad!

iPhone 6s Front Camera and Sensor Cable

Good luck :)

I have this problem and I have found if I connect head phones then it allows me to stop the call and the black screen goes away ... why would this be ? Spoke to apple and they just tell me its a hardware problem and take it to the store or it could be software ... they obviously don't know. I also have iphone 6S and it started after one of their updates a while back last year and I just live with it but its getting worse. Any suggestions as to what it could be ?

@lynnmc it is most likely the front camera assembly. Part of that assembly is a proximity sensor that detects when you phone is up to your face. It blacka out and blocks the screen so you don't press buttons. Using headphones over-rides that function as it seems you have an external headset attached.

I would open the phone and see if that sensor is aligned. Check out the ifixit guides I linked above. An easy way to test it is with voice recorder. During recording the screen will blackout if it is close to something or missaligned.

Best of luck!

I too have an iPhone 6 and the only thing that works is putting in the headphones....this started happening from a back update also.

댓글 1개 더보기

댓글 달기

Hi the problem was the screen, any know why the screen would do this?

해당 답변은 도움이 되었습니까?

점수 1

댓글 1개:

Check screen protector

댓글 달기

I had this problem, and it was because of a slightly misaligned screen protector

해당 답변은 도움이 되었습니까?

점수 1

댓글 1개:

Same problem my mother had with her Iphone XR screen protector was lifted slightly near sensor so I removed it

댓글 달기

Probably water touched the screen. Having same problem. I left the phone in the bathroom and some water splashed on the screen.

해당 답변은 도움이 되었습니까?

점수 0
댓글 달기

귀하의 답변을 추가하세요

Daneil 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 3

30일 전: 13

전체 시간: 30,598