메인 컨텐츠로 가기

The fourth iteration of the popular 7" Galaxy Tab line of Samsung tablets.

139 질문 전체 보기

Samsung tab 4 7.0 won’t turn on after screen replacement

If I hold down power button for awhile, the backlight will come on and go off immediately and it will vibrate a little during this process

...but no logo or battery icon, even after leaving on charge for awhile.

답변함! View the answer 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

점수 0
코멘트 추가

안드로이드 수리 키트

새 스크린 혹은 배터리는 단 하나의 키트로 충분합니다.

지금 장보기

안드로이드 수리 키트

새 스크린 혹은 배터리는 단 하나의 키트로 충분합니다.

지금 장보기

1개의 답변

선택된 솔루션

Hi @wizard870 ,

There's no easy way around it.

If you performed the screen replacement, you'll have to go back and check your work to verify that everything is how it should be. You wouldn't be the first to have overlooked something.

Here's a link to the ifixit Samsung Galaxy Tab 4 7.0 Screen Replacement guide that may be of some help.

If someone else performed the screen replacement, tell them of the problem with the tablet

이 답글이 도움이 되었나요?

점수 2

댓글:

@jayeff thanks for your reseponse. I unplugged the battery first as always, then the digitizer.

I normally don’t take the logic board out on my Samsung tab repairs bc I see it as an unnecessary step. Do you think this may have been an issue?

Thanks

의 답변

Hi @wizard870 ,

Hopefully the heat used on the digitizer panel did not get through to the logic board and affect it somehow.

Can you prove somehow that the replacement screen is OK or have you another one to try?

의 답변

I didn’t think about the heat. The replacement is okay. Do you think it could be the battery flex, seeing how it’s booting on then off? (Without any logo)

의 답변

Hi @wizard870 ,

It mightn't be the battery flex as something may be causing it to shutdown before it gets to showing anything.

Suggest that you disconnect the battery flex and then disconnect all the flex cables that you previously disconnected and clean their contacts with IPA 90%+ (Isopropyl Alcohol). Also clean the systemboard flex cable connectors (that you removed the flex cables from) with IPA 90%+ then ensure that they are all reconnected securely.

Just surmising that you may have inadvertently touched the bare connectors on a flex cable with your fingers and this may have made for a poor connection when the cable was re-inserted. After cleaning them with IPA (use a QTip moistened with IPA to wipe the bare cable contacts and systemboard contacts clean. Wait for it to dry also ensure that there are no fibres coming off the QTip) Then if possible either use gloves or do not handle the bare ends when reinserting the cable into the connector.

Can you get into recovery mode at all?

의 답변

No I am not able to get into recovery mode. Actually, I have to hold power button down for awhile for backlight to even show up. There are two spots on the LCD as well when back light does come on.

I will try alcohol treatment when I am back in the office.

의 답변

코멘트 추가

답변 추가

The Wizard 이(가) 영원히 고마워 할 것입니다.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 6

All Time: 442