주요 콘텐츠로 건너뛰기

Apple iPhone 5s는 2013년 9월 10일에 발표되었습니다. 수리는 이전 모델과 유사하며 스크류 드라이버 및 비집는 도구가 필요합니다. GSM 또는 CDMA / 16, 32, 또는 64GB / 은색, 금색 및 스페이스 그레이.

3530 질문 전체 보기

Restarts after screen replacement

Yesterday I replaced the screen of an iphone 5s. It turns on,works great but after three minutes of using with the screen on it restarts by itselft. If the phone stays locked with the screen off it all work great, the problem is when it is on.

I dont know what it can be, could be a failure in the new screen?

답변되었습니다! 답변 보기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

점수 0
댓글 달기

답변 2개

선택된 답변

There are a few things that could be causing this issue.

  1. Re-install the original screen. If it still works, even though it's cracked, it can still serve it's purpose for troubleshooting. If the original screen works fine, then the replacement is either defective or something went wrong during the installation.
  2. Closely inspect the flex cables on the replacement screen and the connectors on the logic board. Look for signs of damage or debris that would impede a good connection.
  3. Did you keep track of the screws holding the screen retaining bracket? This is critical, especially on the iPhone 5S as all the screws are different length. If you put the wrong one in the wrong hole, you can damage the logic board in what's known as Long-Screw Damage. This would require a micro-soldering repair and is the worst case scenario for your phone.

해당 답변은 도움이 되었습니까?

점수 2
댓글 달기

That’s a new lcd issue. You change the lcd then try it.becuase there are some problems in lcd also when u change lcd,phone gets restarts, type anything in lcd etc.

해당 답변은 도움이 되었습니까?

점수 0
댓글 달기

귀하의 답변을 추가하세요

Julian Sarrelli 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 0

전체 시간: 56