평판: 13
2
1
See photo:
This is a connector for an Ipad Pro charging port. I am replacing this however, when I took the old one off half of this pad came off..
Can I solder to this pad with majority of it gone or do I have to run a jumper? I am just learning so please have some mercy. Thank you!
좋은 질문 입니까?
평판: 781.5k
1.1k
893
2.3k
@smitty1510 yes you can but you better be good at it. No room for fudging and you only have one chance.
해당 답변은 도움이 되었습니까?
@oldturkey03 I need to run a jumper... No schematic or BV available for this model. Not on ZXW either... Any Ideas? How can I find out where to run the jumper?
@smitty1510 there is no way unless you have the schematic.
24 시간 전: 0
7일 전: 0
30일 전: 3
전체 시간: 108
