주요 콘텐츠로 건너뛰기

모델 A1297 Unibody: 2009 상반기, 2009 중반기, 2010 중반기, 2011 상반기 & 2011 하반기

544 질문 전체 보기

Where to start after dropping my MBP, which no does not boot anymore

I bought a non working 2009 17"MBP with aim to fix it. The previous owner said:

"I dropped the computer in a laptop bag off my shoulder. It only turned on completely and functioned normally one time afterwards and only after playing with it and holding down the power button for a long time after taking the battery out, but it worked completely fine. I shut it down and after that I've only been able to turn it on for a second or two before it shuts off." (end quote)

The green charging light on the mag is on, so SMC is communicating.

I am ready to "go in" , I have my brand new rework station , flux, and even schematics and board view, but would appreciate pointers as to where to start in finding what is probably a broken solder joint....besides checking power rail voltages and looking for obvious physical damage....

Update (07/30/2018)

I will try to put in a known good HDD. However, as far as I know a Mac will boot even without any HDD, at least to the point where it shows the folder /question mark.?

이 질문에 답하기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

점수 0
댓글 달기

답변 1개

It could be the Hard Drive, you should inspect that before attempting any rework repairs

해당 답변은 도움이 되었습니까?

점수 0
댓글 달기

귀하의 답변을 추가하세요

Jurgen 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 0

전체 시간: 33