주요 콘텐츠로 건너뛰기

4세대 iPhone. 수리는 간단하지만 앞면 유리와 LCD를 하나의 유닛으로 교체해야 합니다. GSM / 8, 16 또는 32GB 용량 / Model A1332 / 검정 또는 흰색.

2375 질문 전체 보기

Touch screen unresponsive after replacement.

I recently replaced my touchscreen on my iPhone 4 following the guide on here since it was dropped and the LCD was fubar. After it's been replaced the LCD works but the touch sensor doesn't work. Is there any reason for this to happen? There were no issues with the removal and installation of the new screen only a couple of the screws were a pain. This is a 16 GB black model.

Any thoughts?

이 질문에 답하기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

점수 -1
댓글 달기

답변 2개

가장 유용한 답변

There can be several issues:

  1. Connector of the touch is not connected properly
  2. Damaged the touch screen during installation (tare the fragile cable apart or maybe installed some screws wrong which caused the cable to get damaged
  3. Screen is DOA

Good luck!

해당 답변은 도움이 되었습니까?

점수 3

댓글 1개:

Who needs luck with a fixed/broken iPhone?

댓글 달기

I already had this problem when disassembling the phone. In my case, I just cleaned (with alcohol) the digitalizer contact (both, the one at the PCB and the connector cable itself). After doin' it, I let the phone opened for a while to let the alcohol dry by complete. Touch sensor working fine since then.

As said before, don't forget to take a look at the screws positions. They just can't be mixed up, every screw has its right place.

해당 답변은 도움이 되었습니까?

점수 1
댓글 달기

귀하의 답변을 추가하세요

kal1982 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 0

전체 시간: 10,613