주요 콘텐츠로 건너뛰기

2015년 9월 25일 출시. Model A1688/A1633. 수리는 이전 모델과 유사하며 스크류 드라이버 및 비집는 도구가 필요합니다. GSM 또는 CDMA / 6, 64, 또는 128GB / 은색, 금색, 스페이스 그레이 및 로즈 골드로 제공하였습니다.

2688 질문 전체 보기

Why is my iPhone 6s screen only displaying a few seconds aft restart?

I just replaced the screen and the battery to no avail. I was having issues getting the charging port to work originally(few days before), then it did this. After hard reset the screen comes up then disappears a few moments later, no indicator as to why. I noticed once it went off when the raise to activate turned on so I turned that off, still has the same issue. Also weird I don’t see a boot logo. My phone wasn’t turning on at all until I noticed the connector next to the battery came loose. I only see two water sensor stickers and neither are colored nor do I have a reason to suspect water damage. Thanks for any ideas, theories, or assistance

이 질문에 답하기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

점수 0
댓글 달기

답변 2개

가장 유용한 답변

Try booting up the phone without the front camera and home button cable plugged in, sometimes a bad home button / front camera can cause this.

해당 답변은 도움이 되었습니까?

점수 2

댓글 1개:

Thanks, tried it, but no luck

댓글 달기

you may try to put a new battery to test again if the problem still happens probably it is motherboard issue on your phone

해당 답변은 도움이 되었습니까?

점수 0
댓글 달기

귀하의 답변을 추가하세요

Jo kn 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 0

전체 시간: 43