주요 콘텐츠로 건너뛰기

2014년 9월 19일에 출시된 이 5.5” 스크린 iPhone은 iPhone 6의 큰 버전입니다.

1525 질문 전체 보기

Is it possible to fix a broken Pad that connects to the other side?

I was replacing the Touch IC chip on iPhone 6+ but accidentally broke some pads as seen in images below but to fix these pads I would have to wire it to the other side of the board also seen in screenshots of ZXW tool.

Images:

https://www.dropbox.com/s/uw7q0w5z74ui1o...

https://www.dropbox.com/s/336qoy0zutsljo...

https://www.dropbox.com/s/4rte7glffq3fxb...

답변되었습니다! 답변 보기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

점수 0
댓글 달기

답변 1개

선택된 답변

Sure you can but in order to get the micro-jumper to work properly underneath the IC, you will need some very thin wire. You can source 0.02mm enameled wire from most places that sell micro-soldering supplies. You will also need some UV-curable mask to fix the wire in place so it doesn’t shift around when you heat the IC to install it.

Considering you’re asking the question, I will assume that you are starting out. So my advice would be to practice this on a dead board a few times because if you mess this up, the damage it will cause may become un-repairable.

해당 답변은 도움이 되었습니까?

점수 2

댓글 1개:

Do you know any good video tutorial on how to do this when I have the tools? I am practicing on a icloud locked device which I own so that I can practice this skill with my own board as I would feel terrible if I mess on someone else's.

댓글 달기

귀하의 답변을 추가하세요

Cameron Saman 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 0

전체 시간: 67