주요 콘텐츠로 건너뛰기

5세대 iPhone. 수리는 간단하며 스크루드라이버, 비집는 도구 그리고 인내가 필요합니다. GSM/CDMA / 16, 32, 또는 64 GB / 검정색 또는 흰색.

2189 질문 전체 보기

How to fix missing filters & capacitors on logic board?

I recently replaced the screen and digitizer of my iPhone 4S. After reassembling the iPhone turned on and connected to the computer but the screen was black (Apple logo during restart but no backlight) so I took to a technician who took it apart and spotted the problem:

Block Image

I tore off these components: C76, FL4, FL3 and C405.

I have a donor board with all of these components, but the technician told me that FL4 might be harder to resolder since the soldering point has also been torn and that he has to find where FL4 line on the logic board goes in order to solder a wire from FL4. Therefore I wanted to verify that the components I tore are the actually the ones I pointed out and if there’s any other way to successfully resolder the damaged components? Is the bridge the best solution for FL4?

답변되었습니다! 답변 보기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

점수 0
댓글 달기

답변 1개

선택된 답변

It also looks like C21 is missing.

You can get away with not replacing the capacitors but you need to replace FL3 & FL4. Thankfully, FL4 is the one with the damaged pads and not FL3. You will have to run a jumper from one of the components highlighted in red near the PMIC (U5) (below).

Block Image

To the connector (or capacitor C21) in this image. Ideally, you would want to find a way to wire up the FL4 as a a filter and protection circuit but if it can’t be done, then a direct connection will work.

Block Image

해당 답변은 도움이 되었습니까?

점수 3

댓글 1개:

Thank you very much! I will let you know how it works and if I can I will upload pictures.

댓글 달기

귀하의 답변을 추가하세요

Topo Ceni 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 3

전체 시간: 500