Monitor no signal after upgrading

Question

Dell Desktop

Repair Guides for Dell Desktops.

445 질문 전체 보기

Toddu 111 @toddu111

평판: 23

1

게시일: 2019년 7월 21일

옵션

Monitor no signal after upgrading

So I recently upgraded my PC, a Dell Inspiron 5675. I upgraded the GPU to an RX 580, the CPU to a Ryder 2700x, and the PSU to a EVGA 650w silver power supply. It looked fine and seemed to work fine, until I actually tried turning on the monitor. It acts as if there’s nothing there’s and keeps saying No Signal. I’ve tried reseating my GPU multiple times, replacing it with my old one, and putting it in a different slot on the motherboard. I’ve tried a different monitor and different cables, but that has the same result.

답변되었습니다! 답변 보기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

예 아니요

점수 1

댓글 달기

답변 1개

선택된 답변

Alec M @alecm

평판: 1.2k

15

4

게시일: 2019년 7월 21일

옵션

Try putting your old CPU back in. The new CPU you got might be dead.

More things than the GPU can cause no signal. If the issue persists when you put the old CPU and even GPU back in I would try a CMOS reset (depends on the motherboard, but it looks like the jumper for resetting it is right by the coin cell battery in the lower right hand corner of the motherboard).

If none of this helps, the new PSU might be at fault. Worst case scenario, you end up completely undoing all that you changed and see if it works then. Then you can start replacing components with the new ones until it stops working again.

If you could take a picture of that header by the battery, that would be super useful.

해당 답변은 도움이 되었습니까?

예 아니요

점수 2

댓글 4개:

It turned out to be the CPU, I don’t think you understand how helpful this was thank you. I’m going to try to reseat the CPU later and if that doesn’t work get it refunded. Thank you very much. (I also attempted a CMOS reset before but I don’t think it helped.)

Toddu 111 의 2019년 7월 21일

@Toddu 111 You're welcome! I'm glad I could help :)

That's a shame that the CPU is dead, I really hope you can get it refunded/returned.

Alec M 의 2019년 7월 21일

Hi,

It may be that the CPU is not dead it just may not be compatible with the motherboard.

Found this link which might explain the reason why.

jayeff 의 2019년 7월 21일

Ah, that's a good point, the motherboard may not be compatible. I didn't think of that at all. I kinda forgot that there have already been several revisions of Ryzen.

Alec M 의 2019년 7월 24일

댓글 달기

It turned out to be the CPU, I don’t think you understand how helpful this was thank you. I’m going to try to reseat the CPU later and if that doesn’t work get it refunded. Thank you very much. (I also attempted a CMOS reset before but I don’t think it helped.) — Toddu 111
@Toddu 111 You're welcome! I'm glad I could help :)

That's a shame that the CPU is dead, I really hope you can get it refunded/returned. — Alec M
Hi,

It may be that the CPU is not dead it just may not be compatible with the motherboard.

Found this link which might explain the reason why. — jayeff
Ah, that's a good point, the motherboard may not be compatible. I didn't think of that at all. I kinda forgot that there have already been several revisions of Ryzen. — Alec M

Dell Desktop

Monitor no signal after upgrading

답변 1개

귀하의 답변을 추가하세요