820-00239 logic board - temp sensor orientation.

@imicrosoldering U5860 is a TI TMP461 sensor. Here is the datasheet for it. With the writing on the sensor up Pin 1 is to the top left. On your board pin 1 is the bottom left pin so the writing would face to the outside (left hand side).

Due to the size of the sensor,the direction of the sensor is not visible on the teardown .

해당 답변은 도움이 되었습니까?

예 아니요

점수 1

댓글 1개:

Thanks for that. The Mac arrived with paperwork saying “Chip got knocked off” along with the sensor taped to it. It didn’t say all the pads were also missing so I will have to turtle it. I can usually determine which is pad one on the chip if it has two grounds which it has but they must be separate or the chip is faulty. Thanks again Oldturkey.

Chris Stables 의 2019년 8월 25일

댓글 달기

Thanks for that. The Mac arrived with paperwork saying “Chip got knocked off” along with the sensor taped to it. It didn’t say all the pads were also missing so I will have to turtle it. I can usually determine which is pad one on the chip if it has two grounds which it has but they must be separate or the chip is faulty. Thanks again Oldturkey. — Chris Stables