주요 콘텐츠로 건너뛰기

4세대 iPhone. 수리는 간단하지만 앞면 유리와 LCD를 하나의 유닛으로 교체해야 합니다. GSM / 8, 16 또는 32GB 용량 / Model A1332 / 검정 또는 흰색.

2375 질문 전체 보기

Swapped home buttons, now phones won’t connect with AT&T

I have two iPhone 4 devices, and two phone numbers. The home button on the phone I use more often (phone 1) was going bad. Yes, I should have just swapped the SIM cards but I didn’t. I swapped the home buttons instead. It went exactly as expected (the good home button, from phone 2, works great on phone 1, and the lousy home button works just as badly on phone 2 as it used to on phone 1). BUT now neither phone will connect with the cell carrier (AT&T). Phone 2 connected with AT&T weakly (one bar) for a few seconds when first powered up after the swap but nothing since). Both phones alternate saying (upper left) “searching….” and “no service.” I tried swapping SIM cards, resetting network settings, toggling airplane mode and cell data, and updating iOS on phone 1. Nothing. Any ideas/guidance much appreciated.

답변되었습니다! 답변 보기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

점수 0
댓글 달기

답변 1개

선택된 답변

Double check to see if this antenna connector is plugged in which is located right next to the battery connector as shown in this guide:

iPhone 4 Cellular Antenna Replacement

That antenna has a few clips on the loudspeaker housing so make sure those clips are clipped in well into the housing as that can affect antenna performance as seen specifically in step 12.

해당 답변은 도움이 되었습니까?

점수 1

댓글 1개:

Yes! I was not careful with these connectors originally. Once I snapped them into place, the phones picked up the cell network, no problem. Thank you Ben! I’m very grateful.

댓글 달기

귀하의 답변을 추가하세요

HTSMatt 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 0

전체 시간: 35