motion drive belt came off 10 hp 30" deck mower.

I can not seem to get your precise number out of my manuals but posted the 30500 series diagram which is identical. Here are the instructions for the belt change. Good Luck.

해당 답변은 도움이 되었습니까?

예 아니요

점수 3

댓글 3개:

I see how the transmission belt is routed and that is a great help, but how the heck do u get to it...?

rappie1952 의 2017년 4월 9일

what is the belt size? belt is too destroyed to get any numbers

rappie1952 의 2017년 4월 9일

rappie1952 you clicked on the blue link in my original answer? That will tell you how to change the belt. If your mower is identical to the one from the OP then your drive belt has Murray part number 037X65MA and apparently is a 1/2x30inch belt

oldturkey03 의 2017년 4월 9일

댓글 달기

Can you let me know what size belt I need to replace on my Murray 12hp 30 inch — Edith
I see how the transmission belt is routed and that is a great help, but how the heck do u get to it...? — rappie1952
what is the belt size? belt is too destroyed to get any numbers — rappie1952
rappie1952 you clicked on the blue link in my original answer? That will tell you how to change the belt. If your mower is identical to the one from the OP then your drive belt has Murray part number 037X65MA and apparently is a 1/2x30inch belt — oldturkey03

Chris @chrisall 평판: 13 1 · Answer 1 · 2018-09-26T14:08:53-07:00

Chris @chrisall

평판: 13

1

게시일: 2018년 9월 26일

옵션

My 10 hp 30” Craftsman is basically the same as the Murray.

I have found the best way to replace the 37 x 65 motion drive belt is this:

With the pedal disengaged and the front wheels turned to the right, remove the mower deck and the belt. The manual explains how this is done.
Engage the clutch and set the brake. Remove the four nuts from the 1/2” bolts that fasten the transaxle to the mower, but don’t remove the bolts. Remove the nut and the short carriage bolt from the bracket on the rear of the mower.
Raise the rear of the mower about 2 or 3 inches with a floor jack, while observing the four axle bolts. They should stay in the holes of the axle.
Route the motion belt as the manual states, starting from the stack pulley, and work it to the drive pulley. At least one belt guide will need to be loosened during this procedure.
Carefully feel the drive pulley, there will now be enough space to slip the motion belt over it, making sure it is routed correctly.
Reverse the procedure. It takes me about 2 hours to do this.

해당 답변은 도움이 되었습니까?

예 아니요

점수 1

댓글 1개:

Identical to Yard King CE riding mower. I had to reverse the transaxle bolts and slacken off the idler pulley nut but otherwise the procedure worked perfectly. A practical solution, well done.

mmarsh1573 의 2021년 6월 7일

댓글 달기