평판: 1
1
Hey everybody, I upgrade my iMac (Blade SSD + SSD + RAM) and I have a problem. My iMac doesn’t start up properly but only if I press PRAM reset at the start and then he starts properly. I exclude it’s an hardware problem, but I see it like a software/firmware problem.
Suggestions?
좋은 질문 입니까?
평판: 685.3k
3.4k
1.1k
2.6k
Go under the Apple icon to System Preferences > start up disk > unlock it > select the start up disk and close and restart.
해당 답변은 도움이 되었습니까?
평판: 13
2
look up the settings key and change the setting to ahci from regular hdd setting load driver change boot order lots of things but the recovery and setup is on the orignal hdd i think
해당 답변은 도움이 되었습니까?
Recovery and Setup are installed on the new Blade SSD I put in.
Where do I switch setting from AHCI?
24 시간 전: 0
7일 전: 0
30일 전: 1
전체 시간: 43
댓글 2개
Even still run the onboard diagnostics. Reboot and hold the D key. Did you get an error message?
Dan 의
@danj Hi Dan, I just completed and onboard diagnostics with AHT. No problems revealed with exit code ADP000 code.
Leonardo Pera 의