해결됨: Phone not booting after drop. Black screen - iPhone 8

Phone not booting after drop. Black screen

Received an iPhone 8 that was dropped. When I try to boot it up with a power supply it will jump to 250ma and go down to like 100ma and stay there. Black screen with no Apple logo.

Found a line on has no value and I was wondering if that would be the cause. It is on the touch ID connector, SPI_AP_TO_MESA_MOSI-CONN. It is connected to 1 capacitor, filter, resistor, and the CPU. Replaced all the small parts and that leaves the CPU.

Not a lot of experience with iPhone 8 yet so any pointers would be appreciated.

게시일: 2020년 1월 22일

옵션

What do you mean “has no value”? Do you mean it’s reading OL on your meter in resistance mode, reading 0 (ohms or volts) or do you mean something else?

At any rate, if you want to rule things out, just connect the logic board to a known good Lightning flex and battery (or DCPS) and see if the computer recognizes it. After a hard drop, almost anything can happen so there’s no silver bullet here. Probe the main power rails to start, then move onto secondary rails if required. You can also probe the BB subsystem. With more info, we may be able to point you in the right direction.

해당 답변은 도움이 되었습니까?

예 아니요

점수 2

댓글 2개:

Yeah I meant 0L, problem is the NAND. Took it off and my NAND reader cannot get any information of the iphone from it. It says I need to repair when using JC assistant.

Have never done that but I guess the NAND is corrupted?

KWH 의 2020년 1월 23일

Could be corrupted or internally damaged. Let us know what you find.

Minho 의 2020년 1월 24일

댓글 달기

iPhone 8

Phone not booting after drop. Black screen

답변 1개

귀하의 답변을 추가하세요